Coin Slot Strip

I was fortunate enough to have this part made on a small CNC mill at no cost. I made a 3D CAD model of the part from the Club drawings and presented them to the machine operator and about 2 or 3 hours later we produced this.
This was possibly the third part that I made after the skirt but there might have been a shoulder hydraulic in there some where.
This picture also shows some feet/battery box hose that I ordered from Mike Velcheck in September 2005 when the Coin Slot Strip was made.
These have since been superseded by some new individual Coin Slots that I machined in July 2009. I'm not sure yet what I will do with the deep ones.