|
Meyer Dome Ring Gap.JPG
My outer 300mm dome was quite a bit larger than the inner dome
Date: 02/04/2009
Views: 1008
|
Meyer Dome Ring Overlap.JPG
The inner dome and the outer ring needed to be cut in order to get a fit
Date: 02/04/2009
Views: 702
|
Meyer Dome Exterior.JPG
Here's the dome during gluing
Date: 02/04/2009
Views: 783
|
|
Meyer Dome Interior.JPG
Date: 02/04/2009
Views: 844
|
Meyer_Dome_Front.JPG
Despite the many cuts needed the dome came out as planned.
Date: 02/04/2009
Views: 859
|
Meyer_Dome_Rear.JPG
Date: 02/04/2009
Views: 640
|
|
Meyer_JAG_Frame.JPG
This frame was built based on the JAG frame prints, but using Cole's unwelded aluminum dome rings
Date: 02/04/2009
Views: 566
|
R2Leg1.JPG
I built these legs from 0.125 inch aluminum tubing and plate, bonded and flush riveted
Date: 02/04/2009
Views: 766
|
R2Legs.jpg
Date: 12/20/2008
Views: 702
|
|
Meyer_Feet.JPG
The feet were made similarly to the legs, with 0.125 inch aluminum plate bonded, riveted, and machine screwed together.
Date: 02/04/2009
Views: 1039
|
Meyer_R2.JPG
Mechanically assembled, now on to the skins
Date: 01/30/2009
Views: 1419
|
Meyer_Skins.JPG
Here are the skins being glued up- hand-cut aluminum inner, styrene outer.
Date: 02/04/2009
Views: 1025
|
