|
Milling charge door2
To make the door frame I move the guide in 1/16" and make another pass to remove more material.
Date: 10/18/2010
Views: 422
|
Milling charge door3
I adjust the guide or add a larger spacer and repeat the milling process until I have a flat that is 5/16" wide.
Date: 10/18/2010
Views: 465
|
Milling charge door4
I've marked a line at 1/4" from the edge of the frame. Holes have been drilled and it's now ready for cutting with a jigsaw.
Date: 10/18/2010
Views: 454
|
|
Milling charge door5
Cutting out the door.
Date: 10/18/2010
Views: 460
|
Recharge Door Cutout Finished
The finished door frame ready for a styrene or aluminum door.
Date: 10/18/2010
Views: 432
|
tall door milled
Tall door frame milled.
Date: 10/18/2010
Views: 407
|
|
Angle Dremel Guide 1
A guide that I made for the Dremel to run against. It has a piece of alu angle screwed to a scrap piece of PVC pipe.
Date: 10/18/2010
Views: 409
|
Angle Dremel Guide 2
A guide that I made for the Dremel to run against. This guide clamps to the side rail guide.
Date: 10/18/2010
Views: 382
|
Prepped for routing
All the guides have been clamped on and I'm now ready to route the recess into the small front panel.
Date: 10/18/2010
Views: 430
|
|
Router Guides 2
Ready to route
Date: 11/01/2010
Views: 384
|
Tube with doors 1
PVC body tube with cut out doors and panels.
Date: 10/22/2010
Views: 424
|
Tube with doors 2
PVC body tube with cut out doors and panels.
Date: 10/22/2010
Views: 554
|
