|
Disc removed.
Date: 07/21/2018
Views: 250
|
A relief section is marked for cutting on the inner dome for the dome bump castings.
Date: 07/21/2018
Views: 246
|
A Dremel with a cutting disc is used for removing the section.
Date: 07/21/2018
Views: 242
|
|
Cleaning the inside of the laser-cut edges with a file and sanding sticks.
Date: 07/21/2018
Views: 261
|
The top edges are smoothed down with 320 grit sandpaper.
Date: 07/21/2018
Views: 237
|
All lower openings on the outer dome are then sanded and cleaned up.
Date: 07/21/2018
Views: 269
|
|
Panel locations are transferred to the outside as the inside markings will be covered once the inner dome is glued into place.
Date: 07/21/2018
Views: 238
|
To clean the surfaces before gluing, the inner dome and the inside of the outer dome are sprayed with alcohol and wiped down.
Date: 07/21/2018
Views: 269
|
Glue holes are marked and drilled on the inner dome between the upper and lower panel openings.
Date: 07/21/2018
Views: 273
|
|
Cleaning the inside of the outer dome.
Date: 07/21/2018
Views: 229
|
Needle-point applicators for applying the weld-on 3.
Date: 07/21/2018
Views: 263
|
Respirator, gloves and protective eyewear are used when gluing.
Date: 07/21/2018
Views: 224
|
