Three 18" craft rings sandwiched together with wood glue make up the support ring inside the dome.
Date: 07/09/2018
Views: 466
|
After gluing, the rings are clamped together and allowed to dry.
Date: 07/09/2018
Views: 290
|
Sanding the exterior of the dome with 320 grit sand paper. This is done before cutting out the inserts.
Date: 07/09/2018
Views: 300
|
All panels and locations are marked on the inside before removal.
Date: 07/09/2018
Views: 294
|
Panels are removed with a pair of small nippers.
Date: 07/09/2018
Views: 302
|
Panels and ring removed and ready for cleanup.
Date: 07/09/2018
Views: 280
|
Test fitting the inner and outer domes.
Date: 07/10/2018
Views: 314
|
Front PSI hole marked on the inner dome and ready for cutting.
Date: 07/10/2018
Views: 646
|
Dome bumps and rear PSI hole marked for cutting on the inner dome
Date: 07/10/2018
Views: 264
|
Holoprojector hole marked and ready to cut out.
Date: 07/10/2018
Views: 275
|
Starter hole drilled for cutting.
Date: 07/10/2018
Views: 287
|
Using the guide hole, the top holoprojector opening is carefully sawed out.
Date: 07/10/2018
Views: 260
|